Auxiliary Heat
Aux Heat On and a Higher Power Bill?

What Is Auxiliary Heat, and Why Did My Power Bill Jump?
The power bill arrived, it’s much higher than last month, and the thermostat has been showing AUX or AUX HEAT. It’s a common winter call, and it’s easy to assume something is broken.
Sometimes it is. Often it isn’t. Here’s how to tell.
Book OnlineWhat Auxiliary Heat Is
A heat pump warms your house by pulling heat out of the outside air. That works well until it’s cold enough that there isn’t much heat out there to pull.
So heat pump systems include a backup: electric resistance heating elements, usually called auxiliary heat, aux heat, or heat strips. They work like the coils in a toaster, and they turn on when the heat pump can’t keep up by itself.
They work. They’re just expensive. Electric strip heat typically uses two to three times the electricity of the heat pump to deliver the same warmth. That’s the whole story behind most high winter bills.
When Aux Heat Is Supposed to Run
These are normal and don’t need a service call:
- When it’s very cold out. Somewhere in the 30s, depending on your system and your house, the heat pump alone stops being enough and the strips help out.
- When you turn the thermostat up several degrees at once. Ask for a big jump and most thermostats bring on aux heat to get there faster.
- During and just after a defrost cycle. Aux heat covers the gap so you don’t feel a cold draft. See heat pump frozen or steaming.
- On the coldest mornings of the year. A handful of days each winter, it’s going to run.
When It Isn’t Normal
Call us if you see any of this:
- Aux heat running in mild weather. If it’s in the 50s and the strips are on, the heat pump isn’t carrying its load. That often means low refrigerant, a defrost control problem, or a failing compressor.
- Aux heat that never shuts off. It should cycle on and off, not run for days.
- A bill that jumped without the weather explaining it. Compare against the same month last year, not last month.
- EM HEAT showing instead of AUX. That’s different, and it matters. See below.
- The house not keeping up even with aux heat running.
Emergency Heat Is Not the Same Thing
Auxiliary heat is automatic. The system decides it needs help and brings the strips on alongside the heat pump.
Emergency heat is a setting you choose. It shuts the heat pump off completely and runs on strip heat alone. It’s for one situation: your heat pump has failed and you need heat while you wait for a repair.
If your thermostat has been sitting on EM HEAT since a cold snap, that alone could explain your bill. Switch it back to Heat.
Four Things That Make Aux Heat Run More Than It Should
Big nighttime setbacks
With a gas furnace, dropping the temperature overnight saves money. With a heat pump, the system has to recover all that temperature in the morning, and the fastest way it knows is strip heat. You can spend more recovering than you saved. Heat pumps do best held at a steady temperature, or with a thermostat designed for heat pump recovery.
A dirty filter
Restricted airflow makes the heat pump less effective, which brings on the strips sooner. This is the cheapest fix on the list.
A blocked outdoor unit
Leaves, pine straw, or firewood stacked against the side. The unit needs room to pull heat from the air. Give it a couple of feet all around.
Low refrigerant
A system low on refrigerant can still run. It just can’t move as much heat, so the strips pick up the slack and your bill climbs. You can’t see or fix this yourself, and it’s a common real problem behind a surprise bill.
What to Check Tonight
- Is the thermostat on Heat rather than EM Heat?
- When did you last change the filter?
- Is the outdoor unit clear of debris?
- Are you setting the temperature back at night? Try holding it steady for a week.
- Compare this bill to the same month last year.
If all of that checks out and aux heat is still running in mild weather, the system needs attention. Call (252) 285-4050 or book online. We’ll measure what the system is doing instead of guessing. Regular heating maintenance catches most of these problems early.
More Heating Help
Auxiliary Heat FAQs for Wilson, NC Homeowners
Is auxiliary heat bad?
No. It’s a designed part of the system and is supposed to run in cold weather. It only signals a problem when it runs in mild weather or never shuts off.
At what temperature does auxiliary heat come on?
It varies by system and house, but commonly somewhere in the 30s. If yours is running in the 50s, it’s worth a look.
What’s the difference between aux heat and emergency heat?
Aux heat is automatic and runs alongside the heat pump. Emergency heat is a setting you choose that shuts the heat pump off and costs considerably more to run. Use emergency heat only when the heat pump has failed.
Should I turn my thermostat down at night with a heat pump?
Generally no. Big setbacks trigger strip heat during recovery and often cost more than they save. Heat pumps do best at a steady temperature.
Why is my power bill so high with a heat pump?
Most often because auxiliary heat is running more than it should, from a cold stretch, a thermostat left on emergency heat, a dirty filter, or a system that’s low on refrigerant.

Aux Heat Running in Mild Weather?
That usually means the heat pump isn’t pulling its weight. Call Prostar and we’ll find out why, with the price before any work starts.
Call Now (252) 285-4050