Prostar Services branded service truck in Wilson, NC
Prostar Services truck wrapped with the slogan Building Trust by Providing Results, parked at sunset in Wilson, NC
Google 5 stars
4.8 Star Rating | 330+ Google Reviews

Frozen Heat Pump

Steam Is Normal. A Block of Ice Isn’t.

Prostar technician servicing an outdoor heat pump unit

Heat Pump Frozen or Steaming? Here’s What’s Normal

You looked out the window on a cold morning and your heat pump was steaming like something was on fire. Or you walked past it and found the coil covered in ice.

One of those is completely normal. The other one isn’t. Here’s how to tell them apart.

Book Online

Steam Is Almost Always Fine

Several times a day in cold weather, your heat pump runs a defrost cycle. It briefly reverses itself, sends warm refrigerant to the outdoor coil, and melts off the frost that has built up. The melting frost turns to vapor and rolls off the unit looking a lot like smoke.

While that’s happening you may also notice:

  • A whooshing or clunking sound as the system reverses
  • The outdoor fan stopping while the compressor keeps running
  • Cooler air from your vents for a few minutes (see heat pump blowing cold air)
  • Water dripping or running off the unit afterward

All of that is the system working. A defrost cycle typically lasts five to fifteen minutes, and the unit goes back to normal heating on its own.

Light Frost Is Fine Too

A layer of frost on the coil during cold, damp weather is expected. That’s exactly what the defrost cycle is for. If it comes and goes, don’t worry about it.

When Ice Is a Real Problem

Call us if you see any of this:

  • Ice covering the whole unit in a solid shell, rather than frost on the coil
  • Ice that doesn’t clear after several hours, or that’s still there the next day
  • Ice on top of the unit or over the fan, which usually means a drainage problem or a defrost failure
  • Fan blades frozen or hitting ice
  • Ice building back right away after a defrost cycle finishes
  • Ice plus no heat in the house (see no heat troubleshooting)

A heat pump that can’t defrost itself will keep icing until it stops heating, and running it that way can damage the compressor, which is the most expensive part of the system. Ice that isn’t clearing is worth a call the same day.

What Causes It

The common causes, roughly in order:

  • A failed defrost control board or defrost sensor, so the system never knows it should defrost
  • Low refrigerant
  • A reversing valve that isn’t switching properly
  • An outdoor fan motor that has stopped
  • Blocked airflow from leaves, pine straw, or shrubs grown in too close
  • Water dripping onto the unit from a gutter or roofline, which freezes and builds up
  • The unit sitting too low, so melt water pools underneath and refreezes

Those last two are worth checking yourself, because the permanent fix isn’t a repair. Reroute the gutter, or get the unit up on risers.

What to Do Right Now

Don’t chip at the ice

A screwdriver or ice scraper can puncture the coil, and that turns a repair into a replacement.

  • Clear anything blocking airflow: leaves, straw, or snow drifted against the side.
  • Try fan mode. Setting the thermostat to Off and the fan to On sometimes helps clear light ice. Give it an hour.
  • Use lukewarm water if you need to. Never hot or boiling. A sudden temperature change can crack the coil.
  • If it’s a solid block, shut the system off at the thermostat and call us. Running it iced can do real damage.
  • Look up. If water is dripping onto the unit from above, that’s your cause, and it will keep happening until it’s rerouted.

Preventing It

Most icing problems trace back to something a maintenance visit catches: refrigerant a little low, a defrost sensor drifting, a fan motor wearing out, or clearance that has grown in. Fall is the right time to have it checked, before the first hard freeze.

If your unit is iced up right now, call (252) 285-4050 or book online. We answer 24/7. Learn more about our heat pump service in Wilson.

More Heating Help

Frozen Heat Pump FAQs for Wilson, NC Homeowners

Why is my heat pump steaming?

It’s running a defrost cycle, melting frost off the outdoor coil, which turns into visible vapor. This is normal and usually finishes in five to fifteen minutes.

Is it normal for a heat pump to have ice on it?

Light frost on the coil in cold, damp weather is normal. A solid shell of ice over the unit, or ice that doesn’t clear within a few hours, is not.

Can I pour hot water on a frozen heat pump?

Use lukewarm water at most. Hot or boiling water can crack the coil, and never use anything sharp to break ice off.

How often should a heat pump defrost?

Commonly every 30 to 90 minutes in cold, damp conditions, depending on the system and the weather. Much more often than that suggests a problem.

Should I run my heat pump if it’s iced over?

No. Shut it off at the thermostat and call. Running a heat pump that can’t defrost risks compressor damage.

Technician sliding a new filter into a home furnace

Heat Pump Iced Over?

Shut it off and call Prostar. We answer 24/7 and will give you the price before any work starts.

Call Now (252) 285-4050